Porter cable fr350 repair manual


















Bruce for model number Fr asked on Hello Bruce, thank you for your inquiry. Attached is a link to repair instructions. Thank you. Did this question help you? Yes No. My nail gun stop driving nails. Air was leaking at top exhaust. I remove that exhaust cap. It had a lot of broken white plastic. What do I need to fix it? Wiley for model number Fr fr type 2 serial asked on Hello Wiley, Thank you for your question.

We hope this helps! Related Parts: Piston Bumper. Ask a question. Ask our experts a question about this part and we will respond as soon as we can. Join our VIP email list to receive money-saving-advice and special discounts.

Model Number Recommended. Submit your question. Thank you for your question! Our experts will get back to you as soon as they can. Ask Another Question. Continue Shopping. Discussion is closed. How is the piston bumper removed from head? After 20yr it has disintegrated. Question: Nose Cushion Hello , You are correct. It can also be used when you nailing and you don't want the prongs to leave a mark.

Question: Bumper ddot. My nailer just quit working. Air comes out the exhaust, and trigger is slack. Took head off and there is a clear rubber cup shaped part that is tore. It looks to need replacing but not sure what the part name is. Search within model. Page A. Screw, Soc Hd. Add to Cart. Screw, Shcs, M6X1. O-Ring, 2. Screw M4X. Nut, Nylon M5X. Screw, Shcs, M5X0. Popular Parts. Pusher Assembly. Screw,Soc Hd.

Cap M5 X Nut,Esn M6X1. Nailer Parts. Repair Guides Power Tool Care and Maintenance This article suggests guidelines for power tool care and maintenance. My framing gun is leaking from back where the plastic and the aluminum housing meets what do I need to fix the air leak.

Jason for model number FrB asked on Hello Jason, thank you for your inquiry! Did this question help you?

Yes No. Hello repair team, The framing nail gun has a hissing from the trigger. Sometimes it will fire good, but most often will not fire off. Do I need to replace all prongs within the trigger assembly? Also often the trigger pin will not retract after firing. Is this gun a type 1 or 2. Thanks, Phil Model FR serial Phil for model number Model FR asked on Hi Phil, Thank you for your question. Use clean, dry, regulated, compressed air at 70 to PSI, 4. Do not connect tool to pressure which potentially exceeds PSI Only use air hose that is rated for a maximum working pressure of at least PSI Connect tool to air supply hose with a coupling that automatically removes all pressure from the tool when the coupling is disconnected.

Disconnect tool from air supply hose before doing tool maintenance, clearing a jammed fastener, leaving work area, moving tool to another location, or handing the tool to another person. Never use a tool that is leaking air, has missing or damaged parts, or requires repair. Make sure all screws and caps are securely tightened. Never use tool if safety, trigger or springs are inoperable, missing or damaged.

Do not alter or remove safety, trigger, or springs. Make daily inspections for free movement of trigger and safety mechanism. Do not use tool without safety warning label.

If label is missing, damaged or unreadable, contact your Porter-Cable Service Center for a replacement. Only use parts, fasteners and accessories approved by Porter-Cable.

Connect tool to air supply before loading fasteners, to prevent a fastener from being fired during connection. The tool driving mechanism may cycle when tool is connected to the air supply. Always assume the tool contains fasteners.

No horseplay. Respect the tool as a working implement. Operator and bystanders wear hard hat to safeguard against possible injuries. Do not load fasteners with trigger or safety depressed, to prevent unintentional firing of a fastener.



0コメント

  • 1000 / 1000